Re-use of the FRIENDS wig flowers.
----------------------------------

Here are a few pictures on how i re-use the FRIENDS wig flowers.
First idea was to use a rigid tube, but unfortunately the inner hole is too large.

Therefore, I use the tubes from the 1x4 green brick.

How to?

- Start with a green 1x4 brick with a hole in the tube (important).
- Drill a 1.5mm (0,0590551181102362 inch) hole trough the tube.
- Cut the small suport walls between the tube and the brick wall with a cutter knive (watch you fingers and legs!).
- Remove ONE wall (1x4 length) by cutting it with a sharp cutter knive.
- Remove now the 2 small walls (1x1 length) by cutting it with the cutter knive.
- Result should look like the cutted 1x4 brick in picture M4110422.jpg (with long tubes! - picture is the result AFTER cutting the tubes.)
- Build a jig to place the remaining 1x4 brick (See .ldr file & .png picture)
	The green brick presents the cutted green 1x4 brick, facing the remaining 1x4 wall towards the white 2x4 brick, and the tubes towards the blue plate & gray tile.
- Cut now the tubes with the knive sliding against the tile (tube length = 2 plates).
- Due to cutting edges, re-drill the cutted tube with the 1.5mm drill!
- Place now the cutted tube between long nose pliers, with the cutted edge downwards, and squeeze gently to hold the tube upright.
- Press now gently the FRIENDS flower pin into the non cutted tube hole.
- Squeeze gently the shortest stem of a plant flower stem (3741a) between the long nose plier at the thickening of the stem, leaving the whole thinn stem free.
- Press now gently the tube from the FRIENDS flower onto the thinn stem.
- Do this for the next 2 stems.
- Take now a (6255) plant with 3 large leaves and place it on top of the flower stem. If you place the leaves under the flower stem, the stems seems to be too large and doesn't look good.
- Done!

What to do with the remaining short tubes you can see in picture M4110422.jpg?

- This can be delicate to do, but:
- Cut the remaining (verry) short tubes with the cutter knive.
- Remove all remaining edges to get a as round as possible tube.
- Press now gently a FRIENDS flower pin into the tube.
- And press this gently into a large or small plant leave hole.
- Done!


Success!

Kind regards,
Ludo